High strain rate testing can give engineers material data that is more relevant to rapid impact and crash events, according to Instron application engineer and product specialist Andrea Incardona. In an article outlining the case for dynamic characterisation, Incardona argues that simulation accuracy depends not only on model quality but also on how well the material model represents the loading conditions.
Many materials exhibit strain-rate-dependent properties, meaning their mechanical response can change as loading speed increases. A material characterised under quasi-static conditions may therefore respond differently when subjected to a rapid impact or crash. Instron says this is not simply a theoretical consideration.
A 2025 study published in the SAE International Journal of Materials and Manufacturing, “Influence of Strain Rate Effect on Mechanical and Crashworthiness Properties of CFRP Composite Structures,” found that incorporating strain-rate-dependent material properties into crash simulations reduced discrepancies between simulated and experimental results. The discrepancy in peak acceleration fell by 6.5%, while mean acceleration and displacement discrepancies fell by 5.9% and 6.3%, respectively.
Instron says materials can be characterised from quasi-static conditions up to strain rates approaching 1,000/s, depending on the material, specimen geometry and test method. Tests can last only 3 to 10 milliseconds, requiring data acquisition capable of capturing the material response over a very short period.
Why rate-dependent data matters for simulation
If strength, stiffness, deformation mechanisms or failure behaviour changes as strain rate increases, relying solely on conventional data could leave a model unable to accurately represent the conditions experienced during a rapid event. A comparison of the same material at different loading rates would show why capturing that behaviour matters for simulation, according to the article.
Conventional properties such as strength and stiffness remain important, but they do not necessarily show how a material will respond when loading becomes rapid. Two materials that appear comparable under conventional testing may behave differently under high strain rate conditions. Characterising their dynamic behaviour allows engineers to consider how each material deforms, absorbs energy and ultimately fails under loading conditions relevant to the application.
Instron says this becomes particularly important when performance must be balanced against weight. Understanding how candidate materials respond during rapid loading provides another layer of information alongside mechanical properties, helping engineers assess which material offers the most appropriate balance of weight, strength and energy absorption. The article cites automotive crash structures and aerospace components as examples where dynamic material behaviour can inform both material selection and component design.
Moving dynamic data earlier in development
The value of high strain rate testing ultimately comes from what engineers can do with the resulting data. Dynamic characterisation can form part of a development process in which material behaviour is measured, incorporated into simulation, used to compare design options and then validated through physical testing. This makes material testing more than a final check on an existing design.
Engineers can use dynamic data earlier in development to assess whether a material is suitable, refine a component design and understand how changes may affect performance. Accurate data capture remains critical because tests can take place over only a few milliseconds, requiring systems capable of resolving rapid changes in force and deformation.
Instron says its high strain rate testing systems support data acquisition at up to 200 kHz, while digital image correlation can provide additional information about strain development across the specimen. Analysis tools can then support data processing and theoretical modelling.
The result, according to the company, is a more connected approach to product development, where physical testing provides evidence that can improve simulation, inform material selection and refine designs. Material data is only as useful as its relevance to the conditions a component will face, and high strain rate testing gives engineers a more complete picture of performance under rapid loading, Instron says.
