Industrial Machinery

WITT to Highlight Gas Mixing, Pressure Control and Safety Valves at FABTECH 2026

Priya RamanOctober 25, 20265 min read3 views

At a glance

  • The company will use Booth S46114 to discuss its MEM+ mixers, dome pressure regulators and ULTRA valve lines for industrial gas control.
  • WITT Gas Controls plans to exhibit at FABTECH 2026 in Las Vegas, highlighting equipment for precise mixing of non-flammable gases, stable pressure regulation and protection against backflow and overpressure. The company will point to fast mixing response, multiple control interfaces and retrofittable regulator upgrades.
A brushed stainless-steel gas mixing and safety system with valves, a regulator, a buffer tank and a blank touchscreen control panel, set in a clean industrial environment.

WITT Gas Controls, a supplier of gas safety, control and analysis solutions, plans to exhibit at FABTECH 2026, scheduled for Oct. 21–23 at the Las Vegas Convention Center in Las Vegas, Nevada. The company will welcome attendees to Booth S46114 to discuss its MEM+ gas mixers, dome pressure regulators and gas safety valves, with a focus on precise gas mixing, stable pressure and protection of industrial gas systems.

Gas mixing with tight control

The MEM+ mixer series is designed to blend two or three non-flammable gases, including nitrogen, carbon dioxide and oxygen, across a range of industrial applications. Electronically operated motorized proportional valves allow adjustments in 0.1 percent increments. According to WITT, the system can reach a desired mixture in less than three seconds, with accuracy better than plus or minus 1 percent absolute.

Seven interface options, including Ethernet, OPC UA and PROFINET, are intended to support integration with existing systems. Operators can control the mixers remotely through a PC, PLC or machine controller, or directly through a touchscreen interface. Pressure equalization is used to offset supply pressure fluctuations, while continuous inlet pressure monitoring and pressure alarms are included for safe operation. An integrated buffer tank is designed to accommodate changing flow rates. The unit is housed in a splash-proof, brushed stainless steel enclosure and supports maximum inlet pressures of 20 bar and maximum outlet pressures of 10 bar.

Stable regulation and system protection

WITT will also highlight dome pressure regulators that use optimized pilot pressure regulators to maintain stable working pressure as flow rates and inlet pressures change. The company says the design is intended to support consistent process performance and product quality. The improvements can be retrofitted to existing WITT dome pressure regulators without replacing the complete system.

For protection against reverse flow and overpressure, the company will present ULTRA non-return valves and ULTRAVENT safety relief valves. ULTRA non-return valves are described as combining low opening pressures, tight sealing and minimal flow resistance to guard gas systems against unwanted backflow. ULTRAVENT safety relief valves are designed to respond to pressure increases as low as 5 mbar, providing protection when pressure exceeds a safe level.

Booth discussions

At Booth S46114, WITT plans to discuss how these products can be combined for gas mixing, pressure regulation and safety duties. The exhibit will center on the operational requirements behind those functions: repeatable mixture control, stable working pressure and protection against backflow or excessive pressure.

Reported by Priya Raman, Crane and Lifting Specialist.